Model W1787
3
⁄
8" 2600 RPM Air Drill
Instruction Sheet
EYE INJURY HAZARD!
Always wear safety glasses during
use to prevent serious personal
injury!
INJURY HAZARD!
Always disconnect tool from air to
prevent unexpected operation dur-
ing service!
Figure 1. Model W1787.
INJURY HAZARD!
Never exceed 120 PSI!
Quick
Connector
Quick
Connector
Lubricator
Regulator
Introduction
Your
Tool
Air
The Model W1787 is ideal for production drilling
applications. It features a paddle switch with safety
release, 2,600 RPM free speed and 3⁄8" drilling capac-
ity. Recommended air pressure is 90 PSI and average air
consumption is 6 CFM. Includes a 1⁄4" NPT air fitting and
chuck key.
Compressor
Quick
Coupler
Quick
Coupler
Air Hose
Filter
Figure 2. Installing your tool.
Inventory
A. Air Drill......................................................1
1
B.
⁄4" NPT Air Fitting ........................................1
C. Chuck Key...................................................1
Lubricating Your New Air Drill
Lubricate your air drill with pneumatic tool oil. If you do
not have a lubricator installed in your air line, place 1–2
drops of pneumatic tool oil into the air fitting daily, as
shown in Figure 3.
Figure 3. Lubricating directly into air
fitting.
COPYRIGHT © JUNE, 2007 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
#9574JM
Printed in China
|